Category Archives: CCNA Interview Questions

How do you depict an IP address? | CCNA Questions

It can be done in three possible ways: using Dotted-decimal. For example: 192.168.0.1 using Binary. For example: 10000010.00111011.01110010.01110011 using Hexadecimal. For example: 82 1E 10 A1

Posted in CCNA Interview Questions | Leave a comment

What does the show protocol display? | CCNA Questions

routed protocols that is configured on the router. the address assigned on each interface. the encapsulation method that was configured on each interface.

Posted in CCNA Interview Questions | Leave a comment

What’s the simplest way to remotely configure a router? | CCNA Questions

In cases when you need to configure a router remotely, the most convenient is to use the Cisco AutoInstall Procedure. However, the router must be connected to the WAN or LAN through one of the interfaces.

Posted in CCNA Interview Questions | Leave a comment

What are some standards supported by the Presentation layer? | CCNA Questions

Presentation layer supports many standards, which ensures that data is presented correctly. These include PICT, TIFF and JPEG for graphics, MIDI, MPEG and QuickTime for Video/Audio.

Posted in CCNA Interview Questions | Leave a comment

Why is UDP lease favored when compared to TCP? | CCNA Questions

It’s because UDP is unreliable and unsequenced. It is not capable of establishing virtual circuits and acknowledgements.

Posted in CCNA Interview Questions | Leave a comment

What are the advantages of a layered model in the networking industry? | CCNA Questions

A layered network offers many advantages. It allows administrators to make changes in one layer without the need to make changes in the other layers. Specialization is encouraged, allowing the network industry to make progress faster. A layered model also … Continue reading

Posted in CCNA Interview Questions | Leave a comment

What is subnetting? | CCNA Questions

Subnetting is the process of creating smaller networks from a big parent network. Being a part of a network, each subnet is assigned some additional parameters or identifier to indicate its subnet number.

Posted in CCNA Interview Questions | Leave a comment

Explain the benefits of VLANs. | CCNA Questions

VLANs allow the creation of collision domains by groups other than just physical location. Using VLANs, it is possible to establish networks by different means, such as by function, type of hardware, protocol, among others. This is a big advantage … Continue reading

Posted in CCNA Interview Questions | Leave a comment

What are the different IPX access lists? | CCNA Questions

There are two access lists: Standard and Extended. Standard Access List can only filter the source or destination IP address. An Extended Access List uses the source and destination IP addresses, port, socket and protocol when filtering a network.

Posted in CCNA Interview Questions | Leave a comment

How do you configure a Cisco router to route IPX? | CCNA Questions

The initial thing to do is to enable IPX routing by using the “ipx routing” command. Each interface that is used in the IPX network is then configured with a network number and encapsulation method.

Posted in CCNA Interview Questions | Leave a comment